BT VP1000 Guide de l'utilisateur télécharger pdf (Page 11)

• LED

• OFF

Turns your system off

• STAR

Gives a status report

• ON

Turns your

system on fully

• ON

Home

Turns your system on,

using the ‘home’

setting

BT Home Monitor ~ Issue 5 ~ 1st Edition ~ 26_01_ 04 ~ 5725

MOUNTING USING SCREWS

• Remove the front cover using a screwdriver.

• Gently loosen the screw in the middle of the

circuit board, slide the circuit board down and

remove via the keyhole. Fig 10.

• Push out or screw through the mounting

knockouts in the base.

Fig 10.

• Hold the base against the wall at the selected

location and mark the points for drilling. Then

drill the holes and insert wall plugs.

• Attach the bracket to the mounting surface

with screws provided.

• Return the circuit board to the base.

• Re-attach front cover.

Please remember to have installed both

Movement Detectors before continuing.

INSTALLING THE KEYFOB

There is one Keyfob provided with your BT Home

Monitor VP1000 and it is pre-programmed as

USER 1.

You can use it to turn the security system on and

off and to send Emergency messages.

Another 7 Keyfobs can be registered to your

Control Panel.

ACTIVATING THE KEYFOB

Fig 11.

Press ON and ON Home together to send an Emergency alert.

• The Keyfob is supplied with the battery already

installed.

• Press the STAR button. Fig 11.

• Check that the Keyfob LED flashes and that the

Control Panel gives an audible confirmation.

SECTION 2

Flat wall

mounting

knockouts

Circuit board

screw

Corner mounting

knockouts

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 75 76

Commentaires sur ces manuels

Pas de commentaire

BT VP1000 Guide de l'utilisateur Page 11

Commentaires sur ces manuels