BT Converse 2300 Guide de l'utilisateur télécharger pdf (Page 32)

If you experience any problems, please visit 

Wall mounting your phone



Before you wall-mount your BT Converse 1300,

check that you are not drilling into any hidden

wiring or pipes.

Make sure the telephone line cord will reach the

wall socket.





If you need to leave the phone whilst on a call,

hang the handset on the handset park at the top

left-hand side of the base.

1. Unclip stand from the base of the

phone and remove it. Re-route the

telephone line cord towards the

bottom of the phone.

2. Drill two holes in the wall 75-80mm

vertically apart using an 8mm drill bit.

3. Insert the wall plugs if necessary then

insert the screws leaving about 5mm

protruding from the wall on which to

hang the phone.

4. Slot the holes on the back of the base over the screw heads and gently pull the

phone down to make sure it is securely in place.

WALL

WALL PLUG SCREW

75-80 mm

1 2 ... 27 28 29 30 31 32 33

Pas de commentaire

BT Converse 2300 Guide de l'utilisateur Page 32