BT CALLER DISPLAY 60 Guide de l'utilisateur télécharger pdf (Page 9)

Setting up for multiple packs

If you have purchased a BT Verve 450 multiple pack, you will

need to prepare any additional handsets and chargers for use.

For each additional handset and charger:

1. Insert the cable through the channel at the rear of the charger

and insert the plug into the power socket. Plug the other end

into the mains wall power socket and switch on.

2. The NiMH battery is already fitted in the handset. Remove the

battery compartment cover, by sliding it downward and lifting

off. Locate the battery lead and connector and plug it into the

socket inside the battery compartment (the red wire should be

on the left). Tuck the battery leads in the space above the

battery and slide the battery compartment cover back on.

Charge the battery for at least 20 hours.

9Getting started

Using your BT Verve 450 on a

Broadband line?

If this product is to be used on a

broadband line then you must ensure

that it is connected via an ADSL

microfilter. Using this product on a

Broadband line without an ADSL

microfilter may cause problems with

this product and your Broadband

service.

Additional BT ADSL microfilters can be

purchased from www.shop.bt.com

If you experience any problems, please call the Helpline on Freephone 0800 218 2182* or visit www.bt.com/producthelp

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 77 78

Pas de commentaire

BT CALLER DISPLAY 60 Guide de l'utilisateur Page 9